Narrow relative humidity probe Tramex RHP-SNW-B – short, Ø 4 × 127 mm
- SKU: RHP-SNW-B
- VENDOR: Tramex
Couldn't load pickup availability
Safe and secure payments:
Informazioni di prodotto e di utilizzo
Tramex RHP-SNWB short narrow relative humidity probe for in-situ and ambient measurement, 4 mm diameter and 127 mm length, for the CMEX5, MEX5 and Feedback Datalogger DL-RHTX.
Description
The RHP-SNWB is the short narrow probe for in-situ and ambient relative humidity, with a diameter of 4 mm and a length of 127 mm.
Tramex (Ireland) relative humidity probes, with Hygro-i2® technology, measure relative humidity, temperature, dew point and grains per pound inside walls and cavities and in the building's air. Used with the CMEX5, MEX5 or the Feedback Datalogger DL-RHTX, they show all values on the same display. They are reusable, quick to acclimatise and accurate even above 90% relative humidity; calibration can be verified with calibration salt checks.
Relative humidity sensor from 0 to 100%, accuracy ±2.0% from 0 to 99% at 25 °C, resolution 0.1%, drift < 0.25% per year; temperature sensor from -20 to 70 °C with accuracy ±0.1 °C and drift < 0.03 °C per year; PTFE film protecting against water and dust; NIST traceability.
Key features
- Diameter 4 mm, length 127 mm
- Relative humidity, temperature, dew point and grains per pound
- For walls, cavities and ambient air
- For CMEX5, MEX5 and DL-RHTX
- Reusable
Typical applications
- Restoration after floods and water damage
- Building surveys: walls and cavities
Compatible with
- Tramex MEX5
- Tramex CMEX5
- DL-RHTX
Documentation
Selection guide
Tramex RHP-SNWB short narrow probe for in-situ and ambient relative humidity, 4 mm diameter and 127 mm length, for CMEX5, MEX5 and Feedback Datalogger DL-RHTX.
Relative humidity probes connect only to Tramex MEX5, Tramex CMEX5, DL-RHTX. RHP-SW-B (Ø 10 × 110 mm) is the short probe for ambient air, cavities and the Hygrohood; RHP-SNW-B (Ø 4 × 127 mm) and RHP-NW-B (Ø 4 × 260 mm) are the narrow probes for small holes and in-depth measurements in walls and raised floors. SAL75S (for RHP-SW/LW) and SAL75N (for RHP-NW/SNW) salts are used for periodic calibration verification.
If in doubt, contact us: our technical support team will recommend the right accessory for your instrument and application.
Integration and programming
Connect the probe to the instrument using the cable supplied with the probe, wait for acclimatisation and read relative humidity, temperature, dew point and grains per pound on the same display; with the Tramex Meters app the values are recorded and included in the report.
Calibration and repair
Check calibration with the dedicated calibration salt check (75% RH environment) before each measurement campaign and at least once a year; protect the PTFE filter from impact and dirt.
Service: RODER S.r.l. – INNOVACHECK division, Tramex distributor for Italy, will assist you with selection, use and sending instruments to Tramex for certified calibration and repairs. Contact us, stating the model and serial number of your instrument.