Relative humidity probe Tramex RHP-SW-B – short, Ø 10 × 110 mm

Informazioni di prodotto e di utilizzo

Product details Product details

Help in choosing Help in choosing

Integration and programming Integration and programming

Calibration and repair Calibration and repair

Tramex RHP-SWB short relative humidity probe for in-situ and ambient measurement, 10 mm diameter and 110 mm length, for the CMEX5, MEX5 and Feedback Datalogger DL-RHTX.

Description

The RHP-SWB is the short probe for in-situ and ambient relative humidity, with a diameter of 10 mm and a length of 110 mm.

Tramex (Ireland) relative humidity probes, with Hygro-i2® technology, measure relative humidity, temperature, dew point and grains per pound inside walls and cavities and in the building's air. Used with the CMEX5, MEX5 or the Feedback Datalogger DL-RHTX, they show all values on the same display. They are reusable, quick to acclimatise and accurate even above 90% relative humidity; calibration can be verified with calibration salt checks.

Relative humidity sensor from 0 to 100%, accuracy ±2.0% from 0 to 99% at 25 °C, resolution 0.1%, drift < 0.25% per year; temperature sensor from -20 to 70 °C with accuracy ±0.1 °C and drift < 0.03 °C per year; PTFE film protecting against water and dust; NIST traceability.

Key features

Diameter 10 mm, length 110 mm
Relative humidity, temperature, dew point and grains per pound
For walls, cavities and ambient air
For CMEX5, MEX5 and DL-RHTX
Reusable

Typical applications

Restoration after floods and water damage
Building surveys: walls and cavities

Compatible with

Documentation

Data sheet / dimensions: rh probes eu 0425 rev1 0 rh probes data

Selection guide

Tramex RHP-SWB short probe for in-situ and ambient relative humidity, 10 mm diameter and 110 mm length, for CMEX5, MEX5 and Feedback Datalogger DL-RHTX.

Relative humidity probes connect only to Tramex MEX5, Tramex CMEX5, DL-RHTX. RHP-SW-B (Ø 10 × 110 mm) is the short probe for ambient air, cavities and the Hygrohood; RHP-SNW-B (Ø 4 × 127 mm) and RHP-NW-B (Ø 4 × 260 mm) are the narrow probes for small holes and in-depth measurements in walls and raised floors. SAL75S (for RHP-SW/LW) and SAL75N (for RHP-NW/SNW) salts are used for periodic calibration verification.

If in doubt, contact us: our technical support team will recommend the right accessory for your instrument and application.

Integration and programming

Connect the probe to the instrument using the cable supplied with the probe, wait for acclimatisation and read relative humidity, temperature, dew point and grains per pound on the same display; with the Tramex Meters app the values are recorded and included in the report.

Calibration and repair

Check calibration with the dedicated calibration salt check (75% RH environment) before each measurement campaign and at least once a year; protect the PTFE filter from impact and dirt.

Service: RODER S.r.l. – INNOVACHECK division, Tramex distributor for Italy, will assist you with selection, use and sending instruments to Tramex for certified calibration and repairs. Contact us, stating the model and serial number of your instrument.

Order special instructions

Discount